Function of Trap Type: Standing Start Area

ymk16

Hi,

I am trying to setup a circuit layout with a standing start trap and ends with a finish trap.
However, while doing a test run, I noticed that after I moved off from the defined standing start area, the timer will also reset and restart counting outside of that defined area when I come to a full stop and move of again.
Was trying to simulate a spin off event.
This timer restart occurs after and outside the defined standing start area and before the finish trap.

Is this expected?
Please advice.

Thanks.
MK

aol_of_RaceChrono

Timer should start only when starting from inside the standing start area. I'll put to my TODO list to test it if it's broken.

ymk16

Thanks a lot aol.
Looking forward to your reply and solution if any.

aol_of_RaceChrono

This was indeed a problem, fixed in next version v4.3.6. Sorry for the fix taking this long!