i have 2 sets of brake data. 1) brake on/off. 2) some sort of brake pressure.
1) brake on/off i have a can-bus pid that flips a single bit when the brake pedal is pressed any amount
2) i have a value that decreases as the brake it pressed. i assume this is brake pressure, but still unsure of the units
Trying to use #1 for now, until i figure out the pressure PID, but the on/off solution when rendering overlay is weird. it appears that the overlay is interpolating my values, either 0 or 100 (brake off or brake on) and draws the animated from 0 to 100 and 100 to 0. is there anyway to turn off the interpolation? either in the RaceChrono interface or by sending data to represent on/off?
For #2, once i have figure out brake pressure PID units, it seems like the PID editor is expecting kPa as unit. but absolute pressure values can differ car to car, so what does Racechrono use for brakes off and maximum brake when using pressure?